Menu
Ordering Steel Angle Sections
| Angle Leg Out We bend all sizes up to: 10” x 10” x 1” |
 |
 |
| Angle Leg In We bend all sizes up to: 10” x 10” x 1” |
 |
 |
| Angle Heel In We bend all sizes up to: 8” x 8” x 1” |
 |
 |
| Angle Heel Out We bend all sizes up to: 8” x 8” x 1” |
 |
 |
| Angle Heel Up We bend all sizes up to: 8” x 8” x 1” |
 |
 |
- For angle bending with leg out, the radius or diameter is usually specified as measured from the inside leg.
- For angle bending with leg in, the radius or diameter is usually specified as measured from the outside of the vertical leg.
- For angle bending with heel in, the radius or diameter is usually specified as measured from the inside apex of the angle.
- For angle bending with heel out, the radius or diameter is usually specified as measured from the outside apex of the angle.
- When bending angles heel up, the radius or diameter is usually specified as measured from the apex of the angle.
- Particular attention should be paid to the angle bending of unequal leg angles. You must specify short leg in, short leg out, long leg in, long leg out. Otherwise the radius or diameter of such rolled angles is usually specified as measured just as the corresponding equal leg angles.
- Angle bending as small as ½ x ½ x 1/8 to radii as tight as 1-1/2 inch in all the orientations listed above is a common service we provide.
- Our angle bending capabilities go as large as 10 x 10 x 1 to tight radii or large sweeps, again in all the orientations listed above.
- We regularly stock rolled angle rings in diameters from 3 inch to 72 inch. Special rolled angle rings can be produced in one or two days.
View all of our steel sections and how they are bent here
Contact us for more information on angle bending and our other metal curving services.
